Repacking the firmware with different UBOOT files

Post your great articles here :)
Post Reply
User avatar
Posts: 1523
Joined: Sun Jul 15, 2018 11:43 am
Has thanked: 112 times
Been thanked: 328 times

Repacking the firmware with different UBOOT files


Post by em3ka » Thu Jan 24, 2019 12:47 pm

ricklar wrote:
Sun Jan 13, 2019 8:27 am
... solution is to repackage the firmware with different UBOOT files to your specific ram MHz device, AtvX most likely wont work for you.

To unpack stock firmware and pull out the files you need Amlogic CustomizationTool. The Ram and Bootloader need to match for firmware to be usable. The stock files to pull from stock firmware:

Code: Select all

Most Simple solution I could recommend is to Flash stock firmware,
Check both Erase All and Erase Bootloader on stock install,
Then plug in TV make sure box is working then unplug,
Load AtvX LPDDR into Burning Tool,
Only check Erase All,
Not check erase bootloader, that will keep stock Bootloader in place.
Burn img and see if it works.

Erasing stock bootloader causes issues for boxes not tested by developers of ROM, so Burning will use built-in AtvX firmware files "UBOOT" and "bootloader" which may change the RAM MHz speed value too high or too low which will cause box not to boot.
original post by @ricklar

This topic has 5 replies

You must be a registered member and logged in to view the replies in this topic.

Register Login
Post Reply