Hello,
So I flashed the firmware via Card burn tool, on my S905X box, it flashed perfectly, I was able go through the setup wizard only using a USB Keyboard all the way to where it asks for WIFI (as the wifi drivers are not in the installation I could not skip this step).
So I re-packaged the image with the drivers needed but I am unable to boot into recovery, the reset button inside the AV port does not work, I immediately get the ATVXperience TVOS logo and then the google boot animation and it boots to the setup wizard.
I tried copying recovery.img into the SDcard, I tried copying recovery.img on a USB card, I tried flashing the device again but it does not work as the SDcard cant boot into the recovery.
any suggestions?
Reset button or skip?
- ricklar
- Moderator
- Posts: 889
- Joined: Fri Nov 30, 2018 10:30 pm
- Has thanked: 139 times
- Been thanked: 249 times
Buy or borrow a USB-to-USB cable to install firmware with computer. See Tutorials section if need more info on installation.
I thought you were able to skip signing into internet during setup, been a long time since I booted the ROM from fresh install. Try doing setup with Ethernet connected instead of trying only with WiFi.
I thought you were able to skip signing into internet during setup, been a long time since I booted the ROM from fresh install. Try doing setup with Ethernet connected instead of trying only with WiFi.
BE KIND, BE NICE, BE RESPECTFUL TO OTHERS, RESPECT THE MODERATORS,
*IMPORTANT NOTE* ONLY PM MODERATORS OR DEVELOPERS AS A LAST RESORT!!!
My test device: H96 Pro+ 3gb/32gb DDR4 Plus own Tanix, Beelink, Alfawise, X96S, Odroid-N2, Khadas VIM3L, X3, ADT-3, X96-Air
GEARBEST.com
PLEASE ENJOY ATVX!
*IMPORTANT NOTE* ONLY PM MODERATORS OR DEVELOPERS AS A LAST RESORT!!!
My test device: H96 Pro+ 3gb/32gb DDR4 Plus own Tanix, Beelink, Alfawise, X96S, Odroid-N2, Khadas VIM3L, X3, ADT-3, X96-Air
GEARBEST.com
PLEASE ENJOY ATVX!
Had the same problem, so far usb to usb didnt fixed it, it got stuck in 4%.
edit: Hey guys, I can flash the oreo version of the S905x with no issue, but I have no wifi, I cant flash any other room now, I tried shorting the nand chip, but to no avail, it always boots up to the setup, or usb burning tool stucks at 4%
edit 2: nevermind, was just trying the wrong image, just because I thought the mega links were too old, works great on X96 S905x!
edit: Hey guys, I can flash the oreo version of the S905x with no issue, but I have no wifi, I cant flash any other room now, I tried shorting the nand chip, but to no avail, it always boots up to the setup, or usb burning tool stucks at 4%
edit 2: nevermind, was just trying the wrong image, just because I thought the mega links were too old, works great on X96 S905x!