[phpBB Debug] PHP Warning: in file [ROOT]/ext/spaceace/ajaxchat/controller/chat.php on line 220: Trying to access array offset on value of type bool [QUESTION] Dual-boot atvX v4 and CoreELEC possible? - atvXperience : The Forum
Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
I have an H96 Pro H3 TV stick and I recently installed atvX v4 on it, but now I cannot do dual-boot CoreELEC. This worked fine with v2H, but now I cannot not make it run the "regular" CoreELEC 9.2.5, nor the ng version.
I tried flashing both "atvX-s905x_RTL_SSV_v4.0" and "atvXperience_v4_S905X_RT_BCM" - both work fine with a USB Wi-Fi adapter, except for the problem with CoreELEC.
Has anyone been able to run CoreELEC alongside atvX v4?
Thanks in advance.
P.S. For some reason the only atvX v2H image that worked on my stick was "atvXperience_S905W_V2H_FINAL" - the S905X version did not even flash...
or hold the reset button until the power LED has flashed 3 times
I tried this several times - the stick gets stuck at the atvX logo for hours (if i wait that long). I followed the instructions for flashing the SD card on the CoreELEC site, so I do not believe the problem is there...
piperka07 wrote: ↑Mon Nov 30, 2020 10:31 pm
I tried this several times - the stick gets stuck at the atvX logo for hours (if i wait that long).
We use a standard bootloader for android pie and CoreElec ng build works fine with this bootloader (I tested it personally). Which dtb file did you use for this?
piperka07 wrote: ↑Tue Dec 01, 2020 10:19 am
I used gxl_p212_2g.dtb. The one listed for H96 Pro H3 (Dongle). My next planned step is to flash v2H and test if it CoreELEC will work again.
test with gxl_p212_1g.dtb, apparently only 1g RAM was recognized and your device needs a different bootloader configuration. Are the RAM memory chips soldered on both sides of the PCB or only on one side? Please post the photos