adam's personnal rom

[huzhihang32]

The download file disappear now , does anyone has a copy

[ricklar]

The download file disappear now , does anyone has a copy

Adam's Builds got merged into the Final 2019 2G Builds with some updates, but also some bugs still in v2G, depends on what device you have to pick which version to use, 5 different version on S912 firmware.

[huzhihang32]

Got it, thanks for reply.

The download file disappear now , does anyone has a copy

Adam's Builds got merged into the Final 2019 2G Builds with some updates, but also some bugs still in v2G, depends on what device you have to pick which version to use, 5 different version on S912 firmware.

[bumerc]

Hello everyone,
can you guide me on what rom to burn into by Beelink GT1?
It's an ultime LPN1 (beleive it's running LPDDR) and i'm currenlly running "v2FF LPDDR"
Thank you!!

If currently running v2FF, stay with that. Only try v2G_LPDDR if you want to test if it will load. Not 100% ready that it will work for everybody.

v2G_LPDDR Final does not work with Beelink GT1 Ultimate LPN1.
But you can use v2FF. I used it successfully.

Test that, the Bootloader has been updated.

[JanKO]

If currently running v2FF, stay with that. Only try v2G_LPDDR if you want to test if it will load. Not 100% ready that it will work for everybody.

v2G_LPDDR Final does not work with Beelink GT1 Ultimate LPN1.
But you can use v2FF. I used it successfully.

Test that, the Bootloader has been updated.

Sorry, but the device is totaly dead. I am not able to unbrick it with pins, or connect it to the PC. Can I definitely kill the device by flashing the firmware?

[papla83]

v2G_LPDDR Final does not work with Beelink GT1 Ultimate LPN1.
But you can use v2FF. I used it successfully.

Test that, the Bootloader has been updated.

Sorry, but the device is totaly dead. I am not able to unbrick it with pins, or connect it to the PC. Can I definitely kill the device by flashing the firmware?

It's happened to me.
After a lot of pin short cut at a moment I didn't start my device, and at this point each try to burn again works but the burn went slowly (nearly 10 minutes to burn complètely) ... After à little check my device had pins in permanent short cut.

The welding of the two pins was in constant contact because of the repeated crushing that I had practiced with my screwdriver.
After a séparation made with thin flat screw driver my device came-back from the death.

[JanKO]

Thank you for your good idea. I did it for the first time. But I'll check the pins.
Maybe I'm doing something wrong, I've had problems when I bought it. It was very difficult to connect it to your computer. I had to connect USB and power cables at the same time. I hold the button of course. And I could never boot from SD card too.

[papla83]

Just test another USB port on your pc. Maybe a solution. (infact used only back port and not front)

[xmannamviet]

If currently running v2FF, stay with that. Only try v2G_LPDDR if you want to test if it will load. Not 100% ready that it will work for everybody.

v2G_LPDDR Final does not work with Beelink GT1 Ultimate LPN1.
But you can use v2FF. I used it successfully.

Test that, the Bootloader has been updated.

Work for me, T95Z Plus LPDDR3 3GB, thanks, hope comming soon V2H from you

[niki7989]

M8S_PRO_W_ATVX.img , link please