H96 pro Plus: from 3 giga Ram to 1 giga RAM !!

[bumerc]

The image must work on your box, please post the boot log, otherwise I can not help you.

[gracco]

But not update becouse stops at 2%.

[bumerc]

Maybe you have a faulty power supply or USB cable.
Also try to flash with a sd card.

EDIT
- DDR4 devices usually need a bit more power.

- Therefore, please try burning as follows:

1. Start AML-Burning-Tool and select the image file, select options "erase_bootloader and erase_flash".

2. Start the burning process in the AML-B-T.

IMPORTANT
3. Now connect the power supply to the box.

And only then
4. Plug the USB cable into the OTG port of the box.

[gracco]

ok, it is so that ia make, i try to change cable. But why ATV experience 2FF(original) go on?

[gracco]

Not works even with another cable...and supply power

[bumerc]

Not works even with another cable...and supply power

Did you read the "EDIT" above?

[gracco]

Yes i have read....i must test only with SD card

[gracco]

When i plug power or usb cable i have traied to push reset key and no. If i flash another rom tv box not boot and i must open and press pin on chip to go in recovery mode and flash new rom

[gracco]

I test even GT1 rom and works as ATV experience with only 1 GB ram

[bumerc]

When i plug power or usb cable i have traied to push reset key and no. If i flash another rom tv box not boot and i must open and press pin on chip to go in recovery mode and flash new rom

I suggest you first get a uart to usb converter, then we continue at this point. AML Burning Tool does not require the use of the <<reset button>>