Minix neo u9-h support

[francesko251]

Hi,

I installed this rom to minix via burning tool and it is successfuly booted but usb ports and sd card slot don't work. How to fix that? I've checked erase bootloader. Should i uncheck that option and flash again.

[ricklar]

Hi,
I installed this rom to minix via burning tool and it is successfuly booted but usb ports and sd card slot don't work. How to fix that? I've checked erase bootloader. Should i uncheck that option and flash again.

If AtvX is up an running on your box then bootloader is fine and not the problem. Most likely your device has different board configuration and that possibly needs the original DTB file from the stock original firmware. Using Amlogic Customization Tool to do a level 1 unpack to extract the DTB from stock and replace it inside AtvX via unpack and repackage, then re-burn the firmware image.

[antonio6o6]

Did anybody have luck manage USB port Minix u9h I try dtb and it's not working for me

[antonio6o6]

Where is dtb in firmware so I can look for it?

[ricklar]

Where is dtb in firmware so I can look for it

DTB is found in Level 1 unpack of firmware image

Code: Select all

_aml_dtb.PARTITION

[antonio6o6]

okay I did try dtb partition from minix u9h firmware repack on a custom firmware and still no USB working any help

[bumerc]

okay I did try dtb partition from minix u9h firmware repack on a custom firmware and still no USB working any help

use the stock kernel + dtb and bootloader, minix uses other gpio pins to connect usb

[antonio6o6]

I did try dtb and bootloader and then after every pocket install in custom firmware my box Stay on boot. Cool I edit bootloader in what program do I need

[antonio6o6]

I put a custom firmware on my Minix u9h everything is working fine upset USB port I'm trying to get USB port to work I changed already dtb and no luck I try bootloader end will not boot so I reflash it again can somebody help me out here can somebody help me

[ricklar]

I put a custom firmware on my Minix u9h everything is working fine upset USB port I'm trying to get USB port to work I changed already dtb and no luck I try bootloader end will not boot so I reflash it again can somebody help me out here can somebody help me

Bumerc told you what to use.

use the stock kernel + dtb and bootloader, minix uses other gpio pins to connect usb

Kernel + DTB + Bootloader _ all from stock Minix firmware.

If you didn't know...

Code: Select all

Kernel = boot.PARTITION

Bootloader has 4 parts that need to be used together as a set:

Code: Select all

aml_sdc_burn.UBOOT
UBOOT.USB
bootloader.PARTITION
DDR.USB