[HELP] my TX3 mini was bricked

[em3ka]

... There were no bootloader files. Is there a link to them?

Here is tutorial on how to do it.

[kidjej]

Thanks. Will try later today and and respond here.

[kidjej]

didnt help much, in order to flash with atvX i need first to flash with stock fw, I cannot install stock fw, it stucks at 9% with error

also tried shortening the pins, the same as reset hole

any ideas?

[mushonovster]

Dear All

Can anyone help me to resolve this problem? I tried to use Amlogic to re-flash image to my Tx3 mini but i keep getting the below error and it stopped at 9%. When i tried to boot up my tx3 mini the screen is black. appreciate your help

[HUB1-9][Err]--failed:Verify Failed with sha1sum, origin sum "cc2b685b649488346399bbaa9e7fbb5196fa6f17" != gen sum "cd1283a0f48e9fe5dac17150e4cf6169bce18057"

[HUB1-9][Err]--[0x30405004]UBOOT/Partition _aml_dtb/Verify patition/Error result

If shot pin is required can anyone tell me which pin, much appreciated?

Do you have 2018 or 2019 model?
You only need to flash orginal firmware
with amlogic burning tool and that's it you will b unbrick

[kidjej]

Didnt help him, it didnt help me either. It stucks at 9% with the error above

[dorde73]

After many hours finally success!
If your board looks like this then short pin like in picture (yellow rectangle).
Use Tanix TX3 Max & Mini Dual OS Edition – LibreELEC + Android firmware, because original stock firmware stucks at 4%.