Dear All
Can anyone help me to resolve this problem? I tried to use Amlogic to re-flash image to my Tx3 mini but i keep getting the below error and it stopped at 9%. When i tried to boot up my tx3 mini the screen is black. appreciate your help
[HUB1-9][Err]--failed:Verify Failed with sha1sum, origin sum "cc2b685b649488346399bbaa9e7fbb5196fa6f17" != gen sum "cd1283a0f48e9fe5dac17150e4cf6169bce18057"
[HUB1-9][Err]--[0x30405004]UBOOT/Partition _aml_dtb/Verify patition/Error result
If shot pin is required can anyone tell me which pin, much appreciated?
[HELP] my TX3 mini was bricked
- em3ka
- Moderator
- Posts: 1835
- Joined: Sun Jul 15, 2018 11:43 am
- Has thanked: 108 times
- Been thanked: 370 times
Infamous "red board" = clone TX3 mini.
viewtopic.php?f=2&t=967
viewtopic.php?f=2&t=967
Does not help much, you need firmware from manufacturer.
-
- Expert Member
- Posts: 405
- Joined: Sat Sep 29, 2018 6:29 pm
- Has thanked: 28 times
- Been thanked: 23 times
To get wifi working again you have to look for S905w firmware with wifi chip sv6051p.
You do not have the required permissions to view the files attached to this post.
-
- Administrator & Developer
- Posts: 1551
- Joined: Tue Oct 02, 2018 6:19 pm
- Has thanked: 211 times
- Been thanked: 334 times
This device is equipped with a CL9 RAM and most likely will not run with atvX, but only with a custom or original u-boot, even though the error message above shows another problem