[HELP] TX3 Mini Not Working! USB Burning Problem!
-
- Verified Member
- Posts: 27
- Joined: Thu Oct 10, 2019 11:26 pm
- Has thanked: 5 times
Hello, this is my first post in the forum so I hope I am submitting the the right section. I have come today with a problem that has been with me for well over a month and a half. It all started when I installed a dual-boot libreelec firmware to it from the stock recovery. It gave a black screen and the boot text in the small display. I first tried the SD card method, but for some reason it was only detected on my PC (fully functional btw). So then I next tried it with my USB to USB cable I got from Amazon. After loading up the image into USB burning tool, I hit start and then inserted the cable with the TV box reset button pressed. But for some reason, I either got the 0x30201004 error or the 0x10105002 error. I tried everything, atvx firmware, stock firmware, etc. I followed all the directions in the videos I watched, but they didn't seem to work. And I am 99% sure it is NOT a fake box, since it seems to check out after I took a look inside it. So what should I do? Is it bricked?
- em3ka
- Moderator
- Posts: 1835
- Joined: Sun Jul 15, 2018 11:43 am
- Has thanked: 108 times
- Been thanked: 370 times
Do reset NAND chip to flash stock firmware back.pookiepookiensten wrote: ↑Fri May 22, 2020 6:53 pm ...And I am 99% sure it is NOT a fake box, since it seems to check out after I took a look inside it. So what should I do?...
-
- Verified Member
- Posts: 27
- Joined: Thu Oct 10, 2019 11:26 pm
- Has thanked: 5 times
I tried it, but it could not work still fsr. Do you have a picture or something that highlights the location?
-
- Verified Member
- Posts: 27
- Joined: Thu Oct 10, 2019 11:26 pm
- Has thanked: 5 times
For some reason this is what i have on my tanix:
Take a look, what's up with it.You do not have the required permissions to view the files attached to this post.
-
- Verified Member
- Posts: 27
- Joined: Thu Oct 10, 2019 11:26 pm
- Has thanked: 5 times
Here's the pictures in a higher resolution.
You do not have the required permissions to view the files attached to this post.
-
- Verified Member
- Posts: 27
- Joined: Thu Oct 10, 2019 11:26 pm
- Has thanked: 5 times
Dude, if I could give you a thousand thanks, I would. That post fixed the ENTIRE issue, and now atvXperience works on the device! Although I still have one question: will I have to go through the same process for installing any rom? Or will it work without shorting the pins out and such, as that was a real pain.