atvXperience : The Forum

I'm trying to recover my tv box, but whenever I try, the same error appears.
[Romcode / Initialize DDR / Read initialize status / USB Control setup error]

I tried some roms from atvxperience but they all return the same problem, at 2% for and return the mentioned error.

My Tv Box (h96 pro + (s32-v6 lpddr3)), can someone help me?

Try one of these versions for LPDDR3:

https://drive.google.com/drive/mobile/f ... drive_open

Put your device in MASK Rom mode by shortening the pins on NAND chip and flash good working stock ROM or atvX LPDDR3 image from post above.

em3ka wrote: ↑Mon May 25, 2020 11:19 am Put your device in MASK Rom mode by shortening the pins on NAND chip and flash good working stock ROM or atvX LPDDR3 image from post above.


20180717_212341.jpg

Usb burning continues to start, but always stops at 2%, even with shortening pins. I don't think that is bricked.

gabrielxacc2 wrote: ↑Mon May 25, 2020 1:54 pm

em3ka wrote: ↑Mon May 25, 2020 11:19 am Put your device in MASK Rom mode by shortening the pins on NAND chip and flash good working stock ROM or atvX LPDDR3 image from post above.


20180717_212341.jpg

Usb burning continues to start, but always stops at 2%, even with shortening pins. I don't think that is bricked.

it means you didn’t pinch the pins correctly, the device is still in boot loop

my friend ..

I'm having the same problem..

do I have to pinch those 2 pins and keep pinching them while I'm connecting the USB cable to my box and then press the Start button on the program ( USB burning tool ) or I have to keep pinching the pins even after I click the start button ?!!

also please give me the URL link for the correct firmware for my box ..because when I download the ones in the google drive that you added, the USB burning tool is giving me this message (( Parse burning image fail )) ..!!

it's like the USB burning tool is not accepting that image file.

these pictures for my box

Mohannad84 wrote: ↑Mon Jun 08, 2020 3:23 pm or I have to keep pinching the pins even after I click the start button ?!!

yes, keep the pins for about 2sec. short-circuited. FW is linked above

my friend,

When I'm inside the burning tool, I clicked on import image and choose the images file you added in the link, but the burning tool is giving me the following message (( Parse burning image fail )).

see the attached picture.

also if you have the stock ROM for this box or a new firmware that's fixed and without any issues then please give me the URLs for them both. thank you in advance.

Mohannad84 wrote: ↑Tue Jun 09, 2020 8:53 pm When I'm inside the burning tool, I clicked on import image and choose the images file you added in the link, but the burning tool is giving me the following message (( Parse burning image fail )).

did you unzip the image earlier?