Thank em3ka
Nothing.
Following the instructions and installing the terminal in TV BOX
- import (firmware) .img file in USB Burning Tool
- press Start button and leave program running
- plug in usb male to male cable, one end to the tv box (projector) and other end to the computer
- open Terminal and execute reboot update
No firmware that you linked to me has been loaded.
I do not know what else to do...
Thanks again.
[HELP] W95 (S905X)
-
- Verified Member
- Posts: 10
- Joined: Wed Jan 13, 2021 10:28 pm
Yes, USB Burning Tool detects it and reaches 4% giving the error message: Romcode / Switch status / Check connect / Enum device error
reboot update on the TV Box with Terminal Emulator for Android.
reboot update on the TV Box with Terminal Emulator for Android.
Last edited by Enbar on Fri Jan 15, 2021 11:00 pm, edited 1 time in total.
-
- Verified Member
- Posts: 10
- Joined: Wed Jan 13, 2021 10:28 pm
-
- Verified Member
- Posts: 10
- Joined: Wed Jan 13, 2021 10:28 pm
Could not load firmware. I have tried many times and it now breaks at 2% and sends error in UTB (Romcode / Initialize DDR / Read initialize status / USB Control setup error). Removing all other USB devices from the PC sends the same result. On two other PCs the same.
To confirm that there was no USB connection problem, I put firmware M16 S905X 20171030 (Android 7.1.2) again and it loaded 100% without problem.
I appreciate your work but it seems that after so much work I have to settle for Android 7.
Thanks a lot.
To confirm that there was no USB connection problem, I put firmware M16 S905X 20171030 (Android 7.1.2) again and it loaded 100% without problem.
I appreciate your work but it seems that after so much work I have to settle for Android 7.
Thanks a lot.