[HELP] X96mini q6x v2.2 17355 bricked

[soldiaz]

possible, so we must know what procedure does and if it was possible to flash locked bootloader through it

[kokito0]

I first formatted nand and used HDD Raw Copy Tool 1.10 to copy the dump firmware (original firmware from box) to nand

[kokito0]

Need 4 pin wire solder to sdcard box >> d0,clk,cmd and ground
In motherboard need plugin power and short pin crystal to ground and then connected sdcard box to laptop sdcard reader

[em3ka]

...need plugin power and short pin crystal to ground...

Can you mark (d0,clk,cmd and ground) where each wire goes on PCB ?

nand_hack_pins.png

[qontol]

Hi @kokito0 , i need this to if you don't mind

Can you mark (d0,clk,cmd and ground) where each wire goes on PCB ?

also do you using the dump firmware from this post ?

[mention]kokito0[/mention] https://drive.google.com/u/0/uc?id=1nqQ ... t=download

[qontol]

connected sdcard box to laptop sdcard reader

so it was sdcard reader ? i though it was USB plug

[qontol]

Captured and attached hi res photo for marking

20210418_131207.jpg

20210418_131224.jpg

[kokito0]

Hi @kokito0 , i need this to if you don't mind

Can you mark (d0,clk,cmd and ground) where each wire goes on PCB ?

also do you using the dump firmware from this post ?

[mention]kokito0[/mention] https://drive.google.com/u/0/uc?id=1nqQ ... t=download

no this is twrp dump
this is original dump ==> https://mega.nz/file/PsUjGYgK#nBfJ5_EE9 ... rR9i82MZiA

[kokito0]

photos

[kokito0]

D0 > Data0
CLK > CLK
CMD > CMD
Ground (ground from usb port) > short capacitor (i uploaded photo where) to ground.