Beelink W95 remote Tab file
- em3ka
- Moderator
- Posts: 1835
- Joined: Sun Jul 15, 2018 11:43 am
- Has thanked: 108 times
- Been thanked: 370 times
Help me out with this
- open Terminal Emulator from appdrawer
- you need to type in dmesg and press ENTER (on attached usb keyboard or use air mouse remote that has keyboard)
- press a button on remote a couple of times (power a good button to use), now on your usb keyboard type dmesg again
you should see a line that says somthing like "wrong custom code code is ........" I need the information from that line (it should be repeated a few times as you pressed the button a few times).
I'm not sure if its this one, cause it's a little bit different than the one you mentionedem3ka wrote: ↑Sat Jun 19, 2021 7:10 amHelp me out with this
- open Terminal Emulator from appdrawer
- you need to type in dmesg and press ENTER (on attached usb keyboard or use air mouse remote that has keyboard)
- press a button on remote a couple of times (power a good button to use), now on your usb keyboard type dmesg again
you should see a line that says somthing like "wrong custom code code is ........" I need the information from that line (it should be repeated a few times as you pressed the button a few times).
You do not have the required permissions to view the files attached to this post.
- em3ka
- Moderator
- Posts: 1835
- Joined: Sun Jul 15, 2018 11:43 am
- Has thanked: 108 times
- Been thanked: 370 times
Code: Select all
invalid custom:0xae517f80
i can't believe it, it FINALLY works! Thank you very much! I really appreciate your helpem3ka wrote: ↑Sun Jun 20, 2021 1:49 amThanks, factory code is correct, delete all *.tab files and copy remote.tab1 file (fixed above) into the folder #/vendor/etc and give im correct 0644 permissions.Code: Select all
invalid custom:0xae517f80